Integrate old alarm system or wired sensors
Extend the range of the wireless signal from the control panel.
Measure the strenght of the wireless signal.
The SA203 3in/3out bridge module is equipped
with three sets of signal input terminals and
three sets of relay output terminals. Its primary
function is to convert wired products into the
wireless U-Net protocol through SA203. This
allows for the integration of wired alarm systems
into the U-Net environment, enabling the system
(Gateway) to monitor input signals, control relay
outputs, and establish trigger conditions for
input signals to manage relay outputs.
This product utilizes the U-Net wireless two-way
communication control method and can
connect to the Gateway for smart home
integration and functionality.
The SQ201 is a simple tool to assist the Installer
when trouble shooting RF signal in the
customer premise. The device measures RF level
on the frequency band used by VIAS devices
only. This covers frequency bands for Unet 5.0
and older Unet 3.0 devices.
The SA206 is a signal Repeater to extend the range
of U-Net wireless devices. It is fully compatible with
any U-Net 5.0 enabled sensors and Controller. The
Repeater is designed to be installed by a system
installer in cases where signal reception is poor or
extended range is required. The Repeater does not
alter the existing binding network between
Controller and devices, in fact devices do not need
to be physically removed from their mounting
location when adding the Repeater. This allows the
installer to service the user in the shortest time
possible without disrupting to the home interior.
It comes with installer friendly feature such test
mode to indicate signal strength using LED display
and audible beeps for areas not in line of sight such
as corners. Powered by backup battery, this allows
the Repeater to be easily placed anywhere while
searching for its optimum location.
3F., No. 50, Sec 1, Zhonghua Rd., Tucheng Dist.
New Taipei City 23666, Taiwan